Industry dynamics

Many times, there are many people in the reducer industry who say that the shaft of the reducer is broken. Why? Let's have a look.


First of all, there may be a problem with the quality of the reducer. Of course, this is what we usually people can think of, and the main reason is that it is usually produced in the process of using. For example, in the process of using the reducer to accelerate and decelerate, how should we pay attention to and what good methods are available. We have several suggestions for ChinaI reducer.


In some applications, we must strictly abide by this rule, which is not only to protect the reducer, but also to prevent the output shaft of the reducer from being twisted off. This is mainly because if there is a problem with the installation of the equipment and the output shaft and its load of the reducer are stuck, the overload capacity of the drive motor will continue to increase its output, and then the force on the output shaft of the reducer may exceed 2 times of its rated output torque and the output shaft of the reducer may be twisted off.


The reducer is directly installed on the main shaft of the working machine. When the reducer is running, the counter torque acting on the reducer case is balanced by the counter torque bracket installed on the reducer case or other methods. The other end is connected with the fixed bracket.


In the process of acceleration and deceleration, if the instantaneous torque of the output shaft of the reducer exceeds 2 times of its rated output torque, and the acceleration and deceleration are too frequent, the shaft of the reducer will eventually be broken. In view of the fact that this kind of situation appears less, it will not be further introduced here.


When the reducer is calibrated, steel or cast iron blocks can be used. The height of blocks should not be more than three, or wedge iron can be used. However, flat blocks should be replaced after the reducer is calibrated. Attention should be paid to the selection of reducer.


Therefore, we must pay attention to the method and mentality when using the reducer, especially the use of rules to be familiar with.


Return